Nonferrometal

Exclusive Agent for PL, RO, HU, CZ, SL
Nonferrometal is an exclusive agent for rolled products made by AMAG for PL ONLY and exclusive agent for extruded products made by Eural Gnutti Spa for PL, RO, HU, CZ, SL

AMAG EURAL

2017A

EU Green

According to EU directives: 2000/53/CE (ELV) - 2002/95/CE (RoHS)

Presentation

This alloy has high mechanical properties and excellent resistance to fatigue. During machining, it creates quite long chips, Therefore, it is not well suited for automatic lathes.

It can be replaced by 2030 which has the same mechanical properties but has bet- ter machinability, allowing higher productivity.

Main applications

high structural resistance components for aviation, defence, high resistance components, screws and bolts.

Properties

Properties T3/T4
Machinability  
Protective anodizing  
Decorative anodizing  
Hard anodizing  
Resistance to atmospheric corrosion  
Resistance to marine corrosion  
MIG-TIG weldability  
At resistance weldability  
Brazing weldability  
Plastic formability when cold  
Plastic formability when hot  
 

Excellent

 

Good

 

Acceptable

 

Not recommended


Chemical composition

Si 0,20 ÷ 0,80
Fe ≤0,70
Cu 3,5 ÷ 4,5
Mn 0,40 ÷ 1,00
Mg 0,40 ÷ 1,00
Cr ≤ 0,10
Ni  
Zn ≤0,25
Ti  
Zr  
Pb  
Bi  
Al Rem.

Physical characteristics

Density
Kg/dm^3
2,79
Modulus of elasticity
MPa
75.000
Coefficient of thermal expansion
x10^-6/C
23,6
Thermal conductivity at 20°C
W/mk
134
Electrical resistivity at 20°C
Ωmm^3/m
0,051

Mechanical properties

  Temper Rm
MPa
Rp 0,2
MPa
A% HBW
Extruded T4 390 260 9 105
T4* 410 260 11 115
Drawn T3 400 250 10 105
T3* 470 390 11 135

*Typical Eural Characteristics

Production Programme

DRAWN: EN AW 2017A-T3

  • Round: 10mm - 80mm
  • Square: 20x20mm - 60x60mm
  • Flat: 20x15mm - 70x55mm

EXTRUDED: EN AW 2017A T4

  • Round: 30mm - 250 mm.
  • Square: 50x50mm - 160x160mm
  • Flat: 80x40mm - 160x150mm